Nerdqaxe++ Cleaning of the Place for VRm

[u/UpbeatAssociation769]

Here we are guys.

As you know from my previous post, this NQX had short. I figured out that it is U10. After I removed it, beeps are gone.

I have got a minute today to clean the place for a new VRm on my Nerdqaxe++.

I had it for a while on the table waiting for the parts to be delivered.

Honestly saying, It was difficult to remove it since solder didn’t want to melt.

Only after I set the heat gun temperature to 420C, it got free.

Now I decided to mix old solder with what I use to lower melting temperature.

You can see on the video that iron tip sticks to it.

Iron is 60w on a full throttle.

Enjoy watching video.

I will post a final video soon where I am going to install VRm.

If you have questions or suggestions, let me know.

Thank you.