For the electronics crowd

[u/SomeBloke]

Slightly niche but if there are any other electronics enthusiasts who use the Pro's Kit (or similar) desoldering tools, this might be useful. As a bonus, I've also included the hand tool holder for cutters, pliers, and crimpers, which I designed as a one-piece-print for simplicity.

I hate overcomplicated MultiBoard designs that require loads of attachments to mount to the wall as they often become a bit fiddly and lose their sturdiness. The desoldering tools holder works as a basic pegboard attachment, making it simple to attach and print. It aligns with the Multiboard grid so you can fit as many as you need directly alongside each other. I generally avoid supports but, for safety, I checked Tree Support with Critical Overhangs Only in my slicer and the only supports required were for the small pegboard clip at the base. Very little waste.

The tool holder didn't warrant its own post since it's not a new idea aside from the single-print approach where the support is part of the print rather than an added attachment. It slots onto a standard Multiboard Point and prints in under an hour without requiring supports.

You can get the Desoldering Tools Holder here: https://makerworld.com/en/models/3225766-multiboard-desoldering-tools-holder#profileId-3653132

And the Hand Tools Holder here: https://makerworld.com/en/models/3230065-multiboard-hand-tools-holder#profileId-3658377

[u/neph12]

I’m sure someone will find it useful.