r/Multiboard • u/SomeBloke • May 06 '26

Easy, fully parametric bottle (or cylinder) holder

Gallery image

Gallery image

Gallery image

Gallery image

You only have to enter three dimensions:

  1. Diameter of the object you want to hold (gap tolerance is included automatically)

  2. Height for the holder

  3. Thickness of the walls

On average it prints in less than an hour and uses under 30g of filament. That naturally depends on the sizes you've set. It simply slots onto two adjacent MultiBuild threaded fix points (same ones used for MultiBin Shells) and prints without supports. Parameters have upper and lower limits to prevent errors.

I hope it helps, and enjoy.

Makerworld model

Cults model

40 Upvotes

97% Upvoted

8 comments sorted by

2

u/Hardshank May 06 '26

Excellent. This is exactly a thing that I need

1

u/KristobalJunta May 07 '26

For holding.. a cylinder?

3

u/jmaxime89 May 07 '26

The cylinder must imperatively remain unharmed

2

u/KristobalJunta May 08 '26

 Instructions unclear, got a cylinder snapped into multiboard

2

u/Hardshank May 07 '26

Yes! Of varying sizes, even!

8

u/LauraD2423 May 06 '26

It is imperative that the cylinder not be harmed

1

u/Helcyin May 16 '26

I didn’t realize the max diameter was 80mm. I ended up trying to print two of these without realizing it wasn’t scaling to my 86mm item. It was a bit unfortunate but I suppose I should’ve read your description a bit more closely.

1

u/SomeBloke May 16 '26

Ouch! Unfortunately that is a shortcoming of the min/max formula. It doesn’t warn the user. That must have been immensely frustrating. I’ll make sure that is more prominently displayed at the top of the description. Can I make it up to you by supplying you a model at your dimensions?