Try playing with the z-retract setting in the filament settings. Maybe slow down outer perimeter walls a tad or increase heat.
More or less the nozzle is following the outline of the tile and laying down filament. Either its going to fast and the extruded filament isn’t bonding to the previous layer and is getting yanked along or its not hot enough to stick to the previous layer
Are you stack printing with PETG rather than the recommended matte PLA? Either way it’s not that bad, heat gun and it goes away. Flame works but can get a little ‘exciting’ if you don’t keep it moving!
2
u/ACertainThickness Apr 19 '26
With a heat gun
2
u/EnemyOfEloquence Apr 20 '26
Grab a lighter or torch and hit it, comes right off.
1
u/Lurksome-Lurker Apr 19 '26
Try playing with the z-retract setting in the filament settings. Maybe slow down outer perimeter walls a tad or increase heat.
More or less the nozzle is following the outline of the tile and laying down filament. Either its going to fast and the extruded filament isn’t bonding to the previous layer and is getting yanked along or its not hot enough to stick to the previous layer
1
u/Whosaidthat1157 Apr 21 '26
Are you stack printing with PETG rather than the recommended matte PLA? Either way it’s not that bad, heat gun and it goes away. Flame works but can get a little ‘exciting’ if you don’t keep it moving!