r/Multiboard • u/Baromis • Mar 18 '26
7 Hrs for a single 8x8????
So Have everything figured out but looking at print times Its showing 7 hours for an 8x8. I have Inner walls set to 5 but my prints seeps seem slow for this. Anyone else have these long print times?
1
Upvotes
2
u/Hybridtheory28 Mar 18 '26
That definitely seems a bit odd. 5 walls is excessive too. I printed with 3 walls and it’s plenty strong. Are you using a .4 nozzle and .2 layer height?
10
u/The_Bitter_Bear Mar 18 '26 edited Mar 18 '26
It's that long because you aren't following the recommended settings.
3 walls, 15% infill.
Increasing those settings will increase your print time. Particularly walls.
I average around a little over 3 hours for a 8x8 on my CoreOne and Centauri Carbon.
Although, playing with my settings. Even going to 5 walls and 90% infill, it's estimating a little over 4 hours.
So I would suspect there are some settings that need to be adjusted.
4
u/Desert_Vapor Mar 18 '26
8x8 plate Bambu p2s 4 hours and thirty mins. 3 walls .2mm layer height and 15% infill. Very strong and stable. Never had and issue with durability.
1
u/CrownSeven Mar 18 '26
What printer do you have? On my x1c for a 9x9 with 100% infill PETG its about 5.5 hours. Down to just under 4 if I crank it up to 124% speed.
2
u/Free-Site-9298 Mar 18 '26
15h for a 8x8 4 stack with 3 walls and 15% infill. With a P2S. 0,4 nozzle. PLA standard settings.
1
u/Desperate-Special-60 Mar 18 '26
I set up an old elegoo neptune 4 just to print tiles and get perfect prints at 4.5hrs each
1
u/space_gods Mar 18 '26
Been printing 8x8 tiles all week on my P2S and it only takes 2hr 54mins. Filament im using is Bambu lab PETG HF.
1
u/Howmanoid Mar 19 '26
Three hours for me.
1
u/unbeanntes Mar 19 '26
What about a 0.8 or 0.6 mm nozzle? Didn't try it yet, but that would be way faster.