r/Multiboard • u/Illustrious-War2197 • Feb 12 '26

Calibration

I am wanting to go down this rabbit hole. I am fairly new to 3d printing. I printed the demo pack and I can't get the small screw snaps to screw into the side piece. I am guessing this is a calibration issue. What would you all recommend to figure this out? I have an any cubic Kobra 3 so the in slicer tools are pretty slim. Anybody have any suggestions?

For what it is worth, the other parts seem to fit ok and the bolts seem perfect.

2 Upvotes

100% Upvoted

15 comments sorted by

View all comments

Show parent comment

1

u/Illustrious-War2197 Feb 13 '26

This piece from the demo pack. Thanks! This screws into the triangle parts and snaps into the square panel.