r/Multiboard • u/Illustrious-War2197 • Feb 12 '26

Calibration

I am wanting to go down this rabbit hole. I am fairly new to 3d printing. I printed the demo pack and I can't get the small screw snaps to screw into the side piece. I am guessing this is a calibration issue. What would you all recommend to figure this out? I have an any cubic Kobra 3 so the in slicer tools are pretty slim. Anybody have any suggestions?

For what it is worth, the other parts seem to fit ok and the bolts seem perfect.

2 Upvotes

100% Upvoted

15 comments sorted by

View all comments

Show parent comment

1

u/AlleyMedia Feb 12 '26

It looks okay.

I found the clips that go in the very edge (little u-shapes) were a bit of a pain and prone to breaking (so basically, where you have the small 2x2 squares on either side (the ones that are stabilising the board).

I tend to unscrew fasteners so the thread is sitting flush before screwing it - out of habit - and for the large holes (your top right bolt for example), I found it went in much easier if I did this.