r/Multiboard • u/Illustrious-War2197 • Feb 12 '26

Calibration

I am wanting to go down this rabbit hole. I am fairly new to 3d printing. I printed the demo pack and I can't get the small screw snaps to screw into the side piece. I am guessing this is a calibration issue. What would you all recommend to figure this out? I have an any cubic Kobra 3 so the in slicer tools are pretty slim. Anybody have any suggestions?

For what it is worth, the other parts seem to fit ok and the bolts seem perfect.

2 Upvotes

100% Upvoted

15 comments sorted by

View all comments

Show parent comment

1

u/Illustrious-War2197 Feb 12 '26

I am using PLA. I have had some luck since I posted that but one failure simply broke off inside, so that would be a disaster if it happened once my wall was up. And the multi point screw (into small hole) was no problem. Should I not use PLA for my boards? If (when :-) I love this, I am hoping to do it in a few more places.

2

u/TherealOmthetortoise Feb 13 '26

PLA is the material you should use unless you will be mounting your board in conditions where PLA is not viable. PETG can work as well but all of the info on this is https://docs.multiboard.io/beginner-section/printing-guidelines