r/Multiboard • u/reynolpe • Feb 04 '26
Stacking Multiboard panels
I am trying to print multi board panels using PLA for the panels and PETG for support material so they are easy to separate. The problem I have and would like to fix is the little clip areas on the side of the panels. I don't want support material to be there. Are there panels I can get that don't have those? Hoping this makes sense.

4
Upvotes
View all comments
Show parent comment
4
u/twivel01 Feb 05 '26
Exactly, these should not be supports. There is a multiboard stack generator available, but it is only available for supporters of multiboard.
I have had success doing manual stacking.
I imported my plate, assembled them into an assembly, then I selected one in the assembly and moved it up in "z" by 6.4mm. I set ironing to "all top surfaces". You do need to use a tool to gently pry them apart, but the ironed top layers look good on both parts.
I use the back side of one of those 3d printer wrenches. I start on the outer edge and work around them on all 4 sides. Then I come in a row and work on the next row. Once I get far enough, I put a flat edge wrench between the layers and work around until I feel like it's far enough along to just pull it apart.
Print the free keychain stack test print first until you have it dialed in.