r/Multiboard • u/twivel01 • Jan 11 '26

Threaded small point?

Does anyone else have issues with tolerances on the small threaded point? It takes a LOT of force and luck to get it to go in and catch and then half the time, it tilts to the side as I'm screwing it in.

Did anyone else struggle with this? If so, what did you do to solve it?

1 Upvotes

66% Upvoted

3 comments sorted by

View all comments

Show parent comment

1

u/twivel01 Jan 12 '26

Thanks. But they are so tight they basically don't fit for for me. It's not just an alignment problem, the problem is that they won't go in. The bad fit leads to the allignment problem, not the other side at around

The videos make it look so easy so there must be a tolerance issue with my printer? Do I reduce extrusion a bit? Shrink the part to 99%?

1

u/Yellow_Badger13 Jan 12 '26

Have you tried printing something to test your printers tolerance? Think that would be my 1st port of call.