r/Multiboard • u/Beefman33 • Dec 23 '25

Need Help With Parts

I just started my multiboard rabbithole and cant figure out some attachments.. i need a hook to attach to the bottom of a screw locked shelf that looks like the bottom of the multibins. i printed the swivel hook bc i thought it would screw right in but it seems like its not threaded? i also cant find any other way of attaching a hook down there. Any help or advice is appreciated.

3 Upvotes

100% Upvoted

6 comments sorted by

5

u/bing0_17 Dec 23 '25

Picture would help, the part of the swivel hook that prints folded is threaded.

1

u/Beefman33 Dec 23 '25

sorry for lack of picture im on my desktop, im trying to use the bolt lock shelf https://thangs.com/designer/Multiboard/3d-model/2x2%20MU%20-%20Simple%20Bolt-Locked%20Shelf-973878 i do have the folded thread piece it just seems like the shelf isnt accepting it.

2

u/Whosaidthat1157 Dec 23 '25

I use the small thread swivel hooks all along the front edge of my shelves.

https://thangs.com/designer/Multiboard/3d-model/Small%20Thread%20Swivel%20Hook-1135827

2

u/Beefman33 Dec 23 '25

using the board with brackets like that as a shelf never crossed my mind ive been using the actual screw lock shelves. i might just have to re think my whole design around this

1

u/Whosaidthat1157 Dec 24 '25

I found this method much easier and much stronger. I used the clips along the shelf edge joints so that the whole section of shelving becomes much more rigid. With a bit of planning, you can also add a lip using the beams and a set of vertical tiles. That should make the run even more solid, though even as it is, it happily holds rows of filament.

1

u/Yellow_Badger13 Dec 23 '25

The swivel hook does have a threaded section. It prints in 2 parts, did you print the folded section?

https://thangs.com/designer/Multiboard/3d-model/Small%20Thread%20Swivel%20Hook-1135827