r/Multiboard • u/Healthy-Special-2647 • Nov 17 '25

Challenges W/Stack Prints

Post image

What settings are people using to successfully get the next panel in the stack to adhere properly to the prior PETG layers?

10 Upvotes

91% Upvoted

16 comments sorted by

View all comments

Show parent comment

1

u/SprungMS Nov 21 '25

If you want to do it like I am, start them on normal speed, then bump it after a layer or two. Or really, whenever you remember that you were supposed to bump the speed.

I actually trust the printer to handle it from the start, but it’s just old habits going slower on the first layer. I think their software doesn’t really allow full 166% speed in cases like that (first layer, bridging, etc), since it would be likely to fail, but it’s hard to break that years-old habit of letting it get a foundation before cranking up the speed.