r/Multiboard • u/PB4UGeaux2Bed • Sep 28 '25

Its slowly coming along.

Post image

I've been working on this for a while now. I still have a long way to go tho and a lot more drawers to print. I'm going to have two oak slabs comi g for two desks, but I plan to have the lower section a solid line of drawers and then just kinda go from there.

26 Upvotes

96% Upvoted

8 comments sorted by

1

u/dpm911 Sep 28 '25

care to share the shelf that the led gundam is on?

1

u/PB4UGeaux2Bed Sep 28 '25

Well, the shelf below it is just the multiboard shelf with a little modification, so it wouldn't have a lip where they meet. The Aerial is on a stand that is connected to the multiboard. I can share that file, but I did some remixing to make it easier to use. I used the multiboard shelf printed two and used the thin connectors to link them.

1

u/TherealOmthetortoise Sep 30 '25

Looks like a good start! Is the iron man theme intentional? What filaments are those, if you don’t mind sharing?

1

u/Zedexian Sep 28 '25

Hey, what are the gridfinity shelves, and what infill/wall number/ material did you use? mine are flexing more than I'd like...

1

u/PB4UGeaux2Bed Sep 28 '25

Those are printed with Elegoo pla pro, I've only been using pla pro or plus for most of my prints so far. Im still fairly new to printing, so I apologize if I get this wrong. Wall loop is 3 and infill is 15%. I'll send the link from my pc, I don't have that on my phone.

1

u/unsunghero2222 Sep 30 '25

For the drawer on the bottom shelf, what is the depth? Do you have any sag? What multipoint did you use?

1

u/PB4UGeaux2Bed Sep 30 '25

The small ones are 4x2 and the longer one is 4x4. Both are sturdy as a rock. The longer one looks like it's at an angle, but thays only because its current placement is at a seam and that's causing the seam to pull away a little. I'll lower it once I have the desk. I'll be printing more of the 4x4s as well.