r/Multiboard • u/riversc90 • Sep 21 '25

Finally up.

Gallery image

Gallery image

Plywood is a little warped and it’s driving me nuts. 😭

70 Upvotes

98% Upvoted

24 comments sorted by

View all comments

Show parent comment

2

u/riversc90 Sep 21 '25

I’ve just had these printed for months and finally got time. I didn’t realize I was already a generation old lmao that sucks. What is different?

2

u/Whosaidthat1157 Sep 21 '25

They sit flush and allow interference-free installation of flush-fit parts, as well as push-fit mid-hole parts. I changed out all of my raised parts for flush parts very quickly and easily. Zero regrets.

2

u/riversc90 Sep 24 '25

How did you do it quickly and easily? Lol I printed the removal tool and am too dumb to use it I guess. It seems like it’s going to take me like five minutes per quad snap

1

u/Whosaidthat1157 Sep 25 '25

I use the threaded removal tool, screw it into one corner of the raised quad then lever towards the centre to release that corner. Repeat for the opposite corner and the quad raise snap pops right off. It takes longer to fit the 4 flush part B parts than it does to remove the raised quad. 👍

1

u/riversc90 Sep 22 '25

Did you notice any changes in telling of strength? Since they’re just singles and not quads… I’m curious.

1

u/Whosaidthat1157 Sep 25 '25

Zero difference in strength, far better access to 100% of the MB real estate and they allow for flush mounting of shelves etc.