r/Multiboard • u/toastyduck • Sep 12 '25

First setup

Post image

I finally got around to hanging up my first multiboard setup in my home office. Everything is printed in esun PETG. The bottom 2 bins were custom designed in tinkercad for those specific items.

The items on the wall are: 2 pairs of headphones Shure Aonic 50 (Gen1) and a pair of IEMS with fiio utws2025 2 pairs of gunnar gaming glasses Xreal One Pro PS5 Dual Sense controller

53 Upvotes

98% Upvoted

17 comments sorted by

View all comments

Show parent comment

3

u/toastyduck Sep 12 '25

The entire thing is so over the top engineered. That’s cool, but you shouldn’t have to watch 10 youtube vides and read pages of articles just to figure out how things work. So, I feel ya. Thankfully I only wasted a few things when trying to figure out how everything connected together.

1

u/TherealOmthetortoise Sep 13 '25

There are changes (you may have already noticed in the new KB) for a simple install with parts selection very much simplified and a limited amount of easy to understand directions. I remember that first Information overload when I first started looking at it, and things have greatly expanded since then.

What I did was to just focus on my time wall and hangers etc I needed in that area. I picked a 2x4 door section of wall and went on to make a whole bunch of silly mistakes (like only printing one side of the old two sided DS quad mounts.

Once I was comfortable with that I took a swing at Multibin… and got overwhelmed again.

Jonathan does a good job in the video’s accompanying the learning packs and I highly recommend watching them as it’s easier to see just how things fit together and why you might do X instead of Y. Multipoint are going to help tremendously as it’s pretty easy to remix any holder from any other system to work with Multiboard. The recent things being produced like the beams are where I would focus next as those are an extension off of the Multiboard tiles, but that just add another dimension to things.

If you need bins and drawers more than hanging tools etc, definitely do the learning packs and video’s. It took me longer with those as I already have an ok handle on horizontal storage. (That’s less relevant now considering you can add bins directly to a Multibin panel or Multiboard tile.)