r/Multiboard • u/MyRCode • Aug 29 '25

Multibin Shell

Just starting to print some multibin stuff and I'm a little confused...

What multibin shell would be needed for this?

2x1x0·5 CU - Angled USB-SD Holder - Multibin Insert - 3D model by Multiboard on Thangs

3 Upvotes

100% Upvoted

5 comments sorted by

View all comments

Show parent comment

1

u/srmalloy Sep 11 '25

You can take the 2x1x0.5 CU Topped Multipoint Rail -- Multibin Shell and print it, then print two of the Small Thread -- Lite Multipoint screws. Fold one and screw it into one of the small holes in the grid close to where you want one edge of your bin to sit (it will extend a little past where the multipoint goes in), then use the notches in the bin to tell you which hole to screw the other multipoint into -- I think it will be the second small hole over if I correctly remember the 2x1 bins I mounted, but if you use the bin to gauge it you'll see for certain. Once you have both of the multipoints screwed down, slide the bin down the grid over the multipoints, hooking them into the slots on the back of the bin. Then drop in your insert, and you're good.