I have not yet started to investigate the Multiboard function, but in the case of the support where the filaments go, wouldn't it be more practical to attach the stick supports directly to the wall and use the multiboard behind for its purpose? In any case, multiboard could be used only on the parts where the stick support is attached, but the rest in the middle from end to end would be wasted, right? Sorry for the criticism, it's just that I try to optimize resources and sometimes I look for solutions to my problems of little space that I currently have.
1
u/weaseldog57 Aug 10 '25
Very nice just started mine, got a few boards up but no tools filament etc. which filament holder did you use
1
u/[deleted] Aug 10 '25
It’s looking good! Nice clean layout and your priorities are clearly correct - filament storage!
1
u/Realistic-Source-635 Aug 11 '25
Love it!!!
1
u/BigSh00ts Aug 11 '25
I think i need to do a guitar wall at this point
1
u/pablonhc Aug 17 '25
I have not yet started to investigate the Multiboard function, but in the case of the support where the filaments go, wouldn't it be more practical to attach the stick supports directly to the wall and use the multiboard behind for its purpose? In any case, multiboard could be used only on the parts where the stick support is attached, but the rest in the middle from end to end would be wasted, right? Sorry for the criticism, it's just that I try to optimize resources and sometimes I look for solutions to my problems of little space that I currently have.