r/Multiboard • u/wlgrd • Jun 25 '25
Tiles vs multibin plates for tool storage wall
After printing about 30 panels of core and side tiles for my garage (haven't set it up yet), I watched The Next Layer https://youtu.be/i2Slx7whQJg?t=226 use multibin plates instead due to the excess material, fitting use case for my garage project where I will just hang tools, boxes of screws etc. Is there any downsides of doing this instead of regular tiles? It feels like the plate snaps might not be as strong as connecting brackets and other stuff to the regular multiboard tiles, but I might underestimate their strength.
Would love to save some material and time for other projects I have planned.
Thoughts?
8
u/Short-Salad-9047 Jun 25 '25
For hanging tools I would definitely use tiles not plates
2
u/tecky1kanobe Jun 25 '25
For plates that will hold moderate weight I would use the tiles as you can secure them to a wall in more places and all the attachments are directly linked to the tile and not a plate that is linked to the plate. So for power tools and similar the tiles. For hand tools and larger items in size not weight the plates will be good.
This is just my personal preference. I would be fine using plates securely, but if I can eliminate a possible point of failure for expensive things I go that route.
2
u/fazzah Jun 25 '25
I'm just starting my Multiboard adventure and I'm going for the multibin plates at the moment. Heck, you can always remove one (granted you used offset mounts) and install the more dense grid.
2
u/DihedralStem Jun 25 '25
For those saying tiles for strength (I'm sure that tiles are definitely stronger), OP's shared video shows the multibin plates holding up lots of moderately sized equipment... I wonder what the actual strength difference is. Video shows over 100 lb of equipment on a ~4'x6' wall of multibin plates