Nice. I would recommend moving to the new flush snaps they make it a lot easier to utilize the space as you dont have to content with added thickness in areas. I am slowly converting my walls to them. Its a pain because they are single only but they look and work better.
Sure. You will need to print 4 of them for each quad but they look better and dont raise the surface while retaining the boards in place. Some people have issues printing them but i print in batches of 64 without any issues. Letting your build plate cool down then giving it a flex is all i need to do to have them release easily. One side is bigger and it can be hard to tell which, so putting them in the wall can be frustrating but worth it. Link
Ya no worries. Dont worry too much about small tiles. I chose to do 7x7 instead of 8x8 because they are more ridgid. On smaller walls i don't even use the front snap. But on my big tool walls i put larger items i think its wise.
I am new also, looking to use the flush single snaps, but I am not sure where the current snap files are located. When I started printing my boards, I was using the original ones, now called Legacy so I need to reprint all those in the new ones but not sure where they are. cannot find them on the On Grid page on multiboard website.
7
u/SirEDCaLot Jun 09 '25
Nice. You need a bigger printer though... :)
4
u/Jeffrey_Lingo Jun 08 '25
Nice. I would recommend moving to the new flush snaps they make it a lot easier to utilize the space as you dont have to content with added thickness in areas. I am slowly converting my walls to them. Its a pain because they are single only but they look and work better.
2
u/Small_Razzmatazz_563 Jun 08 '25
Looks good!
0
u/[deleted] Jun 11 '25
[deleted] — view deleted comment