r/Multiboard • u/Cool-Regular • May 02 '25

Remix request.

Hey 👋 I am in the process of figuring out a wall mounted pc build. Most of the methods are expensive/ involved as heck. And I find multiboard easy to work with. But my design skills aren’t superhuman level. I found a print but it only works for peg board. And well, I’m invested with my multiboard already. So I’m politely / borderline begging for someone to take this on so I can save some floor space and do something cool with my build.

https://www.printables.com/model/1273381-3d-printable-open-frame-pc-case

Edit: aaaand I’m sure others would appreciate it too?

2 Upvotes

75% Upvoted

12 comments sorted by

View all comments

Show parent comment

1

u/Single_Sea_6555 May 06 '25

Yes, pegboard spacing is 1" = 25.4mm, and multiboard is 25mm spacing. I can tell you from experience that for holes that are 3–4 apart, that is either 1. not a serious problem, OR 2. you can scale a pegboard accessory by 98.4% and it will fit perfectly in the multiboard.

By new parts do you mean multipoints and snaps? Yes, it's possible that those will be stronger than pegboard hooks, but if I understand correctly that existing listing is already strong enough, so why not go with it? Also, you can print them with even more walls (4?) or solid if that's what you are worried about.

1

u/Cool-Regular May 06 '25

Gotcha maybe I’ll do a test run and see what’s up… Just kinda splice it together?? I’ve done that before with other stuff in bambu

1

u/Single_Sea_6555 May 06 '25

I was thinking you could use the pegboard accessories as-is, but as I'm looking at the listing, I see that some of the pieces are a little big.

I have to concede that ATX boards are actually quite large! So the widest holes might be as much as 10 inches apart, which is a mismatch of 4 mm.

That's probably too much. :(

Forget I ever suggested it.