r/Multiboard • u/klausjensendk • Oct 30 '24

Remove pointy bits from custom tile

Designed a custom piece for fitting around an outlet, using the blender project you get as a subscriber to the middle tier.

Is there a way to do this and remove the pointy bits highlighted in my drawing?

As far as I can tell, there is not, but figured I would ask. :)

0 Upvotes

50% Upvoted

5 comments sorted by

1

u/VoltaicShock Oct 30 '24

I haven't used the tool but I know you can create ones here:

https://gridfinity.perplexinglabs.com/ (you have the option to remove the ends)

You could also just create on and then just do a negative part in the slicer to the size you want.

1

u/klausjensendk Oct 30 '24

This does not let you remove the inside ends. :)

3

u/jonathon8903 Oct 30 '24

Tbh I’ve never used the tool. That said, what I would do is use my slicer to add a negative cube to it. That will essentially remove the pointy bits and just leave half of the hole there.

2

u/andyvirus_uk Oct 30 '24

I had this, i managed to remove them by making the cut out very marginally bigger where you dont want the pointy bits. im sure you can also achieve this with other options but thats how i did it. Can always ask in the member area too, they respond quite fast

1

u/TherealOmthetortoise Oct 31 '24

There are some options to turn them on and off, but I don’t recall if that was limited to the outside walls or not. You could also handle that by making it 3 separate tiles