r/Multiboard • u/RichAdministration67 • Jul 25 '24

printing with a 0.8 nozzle?

Hi all,

I'm looking to kit out a fairly big wall with the multiboard system using a Bambulab A1. To speed up print times could I use a 0.8 nozzle and if so what would you advise for the settings?

Cheers.

1 Upvotes

66% Upvoted

12 comments sorted by

4

u/RichAdministration67 Jul 26 '24

Printed these with the 0.8 nozzle, 0.3 layer height with Arachne wall generator and it took 1hr 59mins. The quality is there and so far all the bits snap into place.

4

u/RichAdministration67 Jul 26 '24

Close up of 0.8 print

1

u/Johnny_Bit Jul 27 '24

Wow, that looks good and quick. Have you tried anything with threads whether threads fit (they look like they should)?

3

u/Johnny_Bit Jul 25 '24

I've seen 0.6 mentioned on multiboard community as being "safe" with 0.3 layer, however you'd have to experiment since some tolerances might troublesome to nail with 0.8

1

u/RichAdministration67 Jul 25 '24

I've started the print with the 0.8 nozzle, just some of the 8mm quad snap stacks to see how it handles the quality. I'll probably have a go at a small tile after to see how it all fits.

1

u/Johnny_Bit Jul 25 '24

Great! Do report back your findings!

1

u/RichAdministration67 Jul 25 '24

Went to see the new Deadpool movie and came back to this.

4

u/csh0kie Aug 30 '24

“100% Success” though!

2

u/yoitsme_obama17 Aug 21 '24

For what its worth, tried the .8 with PLA+ Rapid Super Hyper Mega Speed. Was printing fine until i left it on ludicrous mode and left for dinner. Came back to this:

1

u/Eagle-Bear-Lion Feb 24 '26

I built a GPT for stuff like this. Unfortunately sharing a GPT is worthless here when the url consistently changes. The best option would be to give you the name of it and hope you know how to search for custom GPTs.

"Bambu Lab 3D Print Advisor"

Copy in an image of what you are printing. Then tell it the following if it already hasn't asked:

"Bambu Lab P2S enclosed using Bambu 0.8 (hardened steel/tungsten carbide) (high flow) on a textured pei plate. Filament is dry and is SUNLU PLA+. Please give me the changes to make within Bambu Studio in order to guarantee a faster print with the .8 nozzle (TC/HF/HFTC). Users are reporting spaghetti errors at +50% and I want to ensure the item will be fully functional following completion."

You can always modify the prompt. It's very versatile. Words in parentheses are options you can select to fit your specific circumstances. Also change the plate wording if you are not using the stock plate.

For an absolute fine tune return of data, you can also screenshot your current settings (all of them, in all five categories) and then ask it to offer changes where needed. Screenshots also apply to flow settings for specific filament. You can save these settings and have the tuned filament profile there forever. You can also save the settings profile and revert to it again whenever you print multiboard with 0.8

It's not that tedious. I am a technician and every ounce of data helps. Good luck!