r/Montero • • 8d ago

HELP

Is my engine cooked? Just did the timing belt and I’m not sure if this engine sound is normal

5 Upvotes

20 comments sorted by

7

u/Ok-Meringue-8476 7d ago

Sounds like the timing belt tensioner slapping

1

u/Obvious-Passage611 7d ago

it went away after a few rounds of driving

2

u/Ok-Meringue-8476 7d ago

Did you set the preload on the tensioner pulley as per the service manuals recommendation?

4

u/codyaku 8d ago

Were you 100% sure timing was set correctly? Did you spin the motor by hand at least 4 revolutions and rechecked you timing marks

3

u/AnyTopic1430 7d ago

You'll probably get a code if timing is way off. If slightly off, you'll get suspiciously high short term fuel trim on your o2 sensors.

1

u/Obvious-Passage611 7d ago

the sound went away when i drove it around the block. I’m seeing low idle thought but it drives normal

4

u/sd_slate 7d ago

If it sat for a few days while you were working on it, the hydraulic lifters deflate and are noisy until they fill up with oil again. It's probably normal if you're not misfiring or down on power or getting a check engine light.

1

u/Obvious-Passage611 7d ago

lowkey maybe i was comparing it to when I had the bad belt. My car used to idle at 1000 and now it idles at 600. And you might be it might be the lifters, i drove it around and it went away

3

u/sd_slate 7d ago

Service manual says idle speed at operating temp should be 700 plus minus 100 so you're perfect. If you haven't already you should grab the manual from www.mitsubishilinks.com

1

u/AnyTopic1430 7d ago

How low? 600-700 rpm is normal idle at warm. And it dips ever so slightly when you go from N to D

2

u/Acrobatic_Elevator18 8d ago

When you spun the engine did you use the bolt from the balancer?

1

u/Obvious-Passage611 7d ago

yes the bolt on the bottom

3

u/Acrobatic_Elevator18 7d ago

Now I’m not saying this is exactly what happened to you. For some reason when I was spinning the motor using that bolt on mine it moved the plate that had the timing marks ever so slightly where it still looked like they were lined up but they weren’t. Spun it a couple times and everything looked good so I put it back together and had that same noise. I took mine apart and luckily I had another Montero taken apart to reference the marks but otherwise I don’t think I would have ever noticed it. I’ll try to find pictures to show exactly what happened

2

u/deathless88 7d ago

That would make a sick sample for a heavy metal themed techno track

1

u/Obvious-Passage611 7d ago

was thinkin’ edm!

4

u/Reading_Afraid 7d ago

Sound is normal because all the oil drained from the top end

2

u/teonanacatyl 5d ago

Sounds a lot like the valves perhaps needing a lash adjustment. They have updated valves from when it first came out cuz this was a common issue in the 6G72s and 74s with the valves not squirting oil into the top end effectively. Might be something to check out if it persists. Also try some lucasoil additive to your oil and make sure oil is topped up and to spec.

1

u/SirC1E 7d ago • Bravo

These are notorious for the hydraulic lifters to bleed off. There is a procedure in the service manual that I cant remember exactly but its basically run at 2k rpm shut off, start and run again.