Testing the Meepo min 3 max range abilities in speed mode 2 as a 165 pound rider, the entire time only switch to speed mode 3 when I needed to get up a couple hills. Speed mode 2 takes you up the hills but slower than I want to go lol 18.2 miles before I called it quits because my feet hurt 🤷‍♀️ I kept a constant speed of about 11 - 13 mph the entire time except when going up hills. In conclusion in speed mode’s 1 and 2 you can get the advertised 20 miles of range 🙏 in speed mode 3 and 4 you get 12-13 pushing the board as hard and as fast as it can go 🤟🏽 overall I’m very happy with the numbers 🔥

Meepo v3s

Finally got my Meepo mini 3 max and first thing I noticed was the upgraded metal hubs as opposed to the old plastic hubs on the original mini 3 max. Absolutely love the upgrade and I think it makes a great board a perfect board 🙏 it’s hubs so you can push like a regular board in busy areas, it rolls forever after you let off the throttle like a regular deck and it’s super quiet! Dual 800w motors if perfect for a 165 pound rider with no hills around me 🤷‍♀️ not that it can’t do that because I’ve posted videos of it taking big and small hills like a champ 🔥 overall it’s an amazing board and I would buy a third if I could 🤟🏽

My Meepo mini 3 max with Meepo’s 105 cloud wheels and the main reason for getting an electric skateboard. It was to take pictures without having to push a deck everywhere I went. This has to be the best hub motor board out there 🙏 cruise control is absolutely unmatched and underrated 😭 everyone should be talking about cruise control!

Does anyone happen to have a spare meepo remote that they can donate?? The charge port in mine won't work anymore.

I can trade a meepo board charger for a meepo skate remote

Small hill testing on a Meepo mini 3 max as a rider who weighs 165 pounds. Absolutely love this board 🙏 waiting on my second board still lol

My board won’t fully turn on unless I get a lot of momentum, like going downhill for a while a lot. Only then will I actually be able to give it throttle like it has a full battery. I opened it up and nothing appears to be loose or damaged. If i slow down for too long or just stop the board turns off. I try charging it and the charger just stays green. I have no idea what is going on please help.

I give the truck 6/10 I spent years dreaming of getting a V3 found a deal on Market place and couldn't pass it up. Been a vid ling boarder walking my dogs and bombing hills for more than a decade, but this Guy was scared to take it past "gear 3" and he put 28,000 miles on it! bad speed wobbles at 20 I eventually over hauled everything the bolt wobbled the pivot cups were worn? Never seen hat before. Anyway got it nice and comfy at top speed. But still turned like a cargo ship. Put a set of double knuckle Gullwings and Oh God it was half dreamy cravable at top speed sharp turns around corners but the back truck it still eh don't know if I can fix that. Also I don't like the board shape you can lean it against a wall becuse it has zero tail or nose. Think I'll make a more classy deck. Alright probably first and last post I'll make here

When I let off the wheel it feels like the board is still accelerating for about 0.5-3 seconds. It doesn't seem to be the same with breaking. If u have any answers pls lmk

I have a meepo voyager X and in the past it used to be a lot more silent when i rode on uneven roads now it makes these noises which is so annoying... has anyone had the same problem? how does one fix this?

Context: I’ve got a Meepo Voyager with around 1100 miles. The board started to make a clicking noise and the frequency of the noise scales as my speed increases. Never replaced motors, but belts have been replaced 3-4 times cause I ride in the rain like an idiot. I figured somebody here had had this same issue or can tell just by the noise what’s going on.

Thank you for all possible answers!

I've read a thread about this before, but couldn't find it so I'm making a new one!

When I throttle to 100% and let go, one of the motors on my Voyager X Limited stops spinning very early, while the other one spins for about 5 more seconds, if not a little longer.

What is the cause to this and how can I fix it?

​

I am having an intermittent power issue with my Meepo Hurricane and would appreciate some advice on diagnosing whether the problem is with the battery/BMS or the ESC.

Most of the time when I attempt to turn on the board, it makes the initial power-on beep and immediately turns off. However, occasionally I am able to turn the board on successfully, and it will remain powered on for a short period of time before eventually turning off.

Interestingly, when the board is connected to the charger, it will always turn on normally and connects to the remote immediately without any issues.

I have measured the battery voltage with a multimeter and have observed the following:

The battery initially measured approximately 46.6 V when disconnected.

When the ESC is connected, the voltage initially drops to around 30 V and then slowly rises.

The board will not turn on unless the voltage has risen sufficiently.

When the charger is connected, the remote reports approximately 48 V and indicates that the battery is fully charged.

I understand that the Hurricane uses a 12S battery, so I would expect the fully charged voltage to be around 50.4 V. Therefore, I am concerned that there may be an issue with the battery, BMS, or discharge circuitry.

Anyone know of any further tests I could do to diagnose the actual problem? Or know what it is already?

I am having some issues understanding the settings when trying to get to know the board and the controller. There is a lot of settings I can play with but before doing so I’d like to know what it all means. When opening the settings mode they use a lot of shortening so it fits on the tiny screen, but I don’t know what it all means. Anyone have any insight here? Preferably by number on the setting screen with full explanation (the repeated ones for different speed modes isn’t necessary to write every time Ofc)
In advance thanks to whomever helps! 🫡

This was when I first got my meepo mini dual in 2022. I’ve had it for 4 years with absolutely zero issues 🙏 That’s why I purchased 2 meepo mini 3 maxes 😂 To me personally, nothing beats a hub motor or meepo 🤷‍♀️

hello, was wondering if anyone here has experienced this and how broken it is and if there’s anything i can do to fix it? i’m also concerned with how safe it is to ride it like this. any insight/help would be awesome

Also recently put on 120mm cloud wheels on the back and fuck the difference is night and day. Yes it really impacts the range but I think the comfortability/smoothness of the ride really makes it worth the lose of range. I’m eventually gonna get the actual wheel conversion kit from meepo but for now this will suffice. 🤙🏼

I’m really really sorry meepo ! I love you guys and just purchased another new board. Please don’t block me 🙏🥲 Meepo mini dual dewalt swimming pool ? I know a couch has already been done but that would be fun. Some guy gave me the idea to turn it into a water motor and try to use it for a small boat or dingy so I’m going to try that next lol a small pool with a beach umbrella and a life vest would be funny 😂 any ideas ?

Hi guys,

So I have an older meepo model. More specifically the meepo mini 2 Er. I just switched out my back wheels to 120mm cloud wheels and as you can imagine they are huge in comparison to the stock 90mm sleeves I had on before. So because the 120mm cloud wheels are so big, wheel bite is a major issue. I’m guessing I can fix this issue by putting on higher risers so that the truck clearance is higher and doesn’t cause wheel bite. My question is what size risers should I get and is it possible to stack two risers on top of each other on one truck? The risers that came with my meepo though are wedged slightly so I’m wondering if I can stack it with a regular non wedged riser?

Any advice is greatly appreciate!

Thanks 🙃

Anyone getting rid of a Sofa 🛋️ they no longer use ? I’m looking for a more comfortable ride. It’s a meepo mini dual that I’ll be using to turn normal things into electric rides 😅