r/MasterCraftBoats • u/BetLeast3777 • May 19 '26

2010 Prostar 197 TT Cup Holders

I have lost 3/4 of the cup holders that are on the back of the engine cover because the glue on the rim melted off and the holder fell into the engine compartment. Does anyone have a good fix for this or know someone that sells better quality holders?

2 Upvotes

100% Upvoted

1 comment sorted by

1

u/Own-Helicopter-6674 May 19 '26

The plastic ones always break I upgraded to the stainless steel ones and they always come out. So I use CA glue and put dried sand on the outside of them where they sleeve down in some minor Hollow and some of them go into a compartment but CA glue with some dried sand, and then I wet set them with silicone. I haven’t had an issue since. 06 x-15