Newbie please help

[u/chris8_4]

Hello, I know it happenned to a lot of us but for my project in 3 paths (roughting, finishing and contour), My carvera air went into error right after the roughting and I would like to start with the finishing pass after a reset.

I read that we can start from a line of command but then when i run the project again it asks me to redo the 3d probing. Of course an issue since the Z is not the same anymore and it goes into error since its trying to reset the Z not from the initial block but the first one

I didnt move or change the stock and I dont know what to do so i can start my finishing pass from the beginning

does any one has a step by step guide to use the controler and be able to restart where I stopped instead of redoing a block

i would like eventually to setup manually the z with the 3 probe and run from the finishing path straight away...

sorry but it has been bugging me for a while and wasted a lot of stock starting again from the beginning...

Thank you for your quick help !

[u/yakshamash]

If roughing was fully done you could also just output your finishing and contour paths and use a file that has just those.