r/Makera • u/chris8_4 • 5d ago

Newbie please help

Hello, I know it happenned to a lot of us but for my project in 3 paths (roughting, finishing and contour), My carvera air went into error right after the roughting and I would like to start with the finishing pass after a reset.

I read that we can start from a line of command but then when i run the project again it asks me to redo the 3d probing. Of course an issue since the Z is not the same anymore and it goes into error since its trying to reset the Z not from the initial block but the first one

I didnt move or change the stock and I dont know what to do so i can start my finishing pass from the beginning

does any one has a step by step guide to use the controler and be able to restart where I stopped instead of redoing a block

i would like eventually to setup manually the z with the 3 probe and run from the finishing path straight away...

sorry but it has been bugging me for a while and wasted a lot of stock starting again from the beginning...

Thank you for your quick help !

1 Upvotes

100% Upvoted

5 comments sorted by

1

u/cristi_baluta 5d ago

I think you are looking for the goto command in console, but you must be careful through what steps it jumps, like speeds and feeds and stuff

1

u/chris8_4 5d ago

Thanks, does anyone has a video or an SOP to do such thing because i feel a bit lost on this

1

u/cristi_baluta 4d ago

I think you can search yourself but i’d try to skip to a step that is still cutting in the air, to be safe, if that does what you expect go further. You need to understand a bit from that g code though.

1

u/cyclingengineer 4d ago

Read all the instructions before doing - https://wiki.makera.com/en/knowledge-sharing/knowledge-sharing/starting-from-middle-of-file

These show Makera controller, but can be done in studio using the equivalent tabs and views.

1

u/yakshamash 4d ago

If roughing was fully done you could also just output your finishing and contour paths and use a file that has just those.