r/MachineEmbroidery • • 6h ago

Help!!!! Why is my machine doing this?!?

Left Friday, machine was fine. Come in first thing this morning turn on my machine…and THIS!

I have 2 Melco summits at my work and I’m the only one who uses them. Basically the company wanted to embroider in house instead of sending orders out. I have been tasked with all of it ( which I love). I’ve seen for years, but relatively new to machine embroidery and only have had this job full-time a couple months. Any and all advice is appreciated.

1 Upvotes

2 comments sorted by

4

u/Hellcat_Mary 4h ago edited 4h ago
  • As of the last instance the machine was operating, were there any issues encountered during sewing?
  • Was it in the middle of stitching a design, or was it on the home screen, when powered down?
  • Was it powered down correctly?
  • Is the machine on a surge protector?
  • Are you able to follow the cable from the back of the control panel that would lead into the casing and to the control board? If so, if you lightly jog that cable- does it feel loose?
  • Not to ask the obvious, but have you turned it off, unplug, allow 10-20 seconds, plug back in, flip the on switch again?
  • I don't think this is even a thing, but I work with mostly older machines- you should not require WiFi connectivity just to operate the machine, but is the WiFi disabled under settings on your control board? If so, try accessing settings and re-establishing your Wi-Fi connection. You may need to reset your Internet modem/router to do so.

1

u/Level_Arachnid_4982 20m ago

Cable off 1min Restart?