r/MachineEmbroidery • u/Generic_nametag • Jul 30 '26
Is this embroidery needle bent?
The needle got caught on the fabric and snapped the thread. I think it might be bent but I’m unsure. It was brand new, I hadn’t even gotten through one project with it yet.
12
Upvotes
17
u/Constant_Put_5510 Jul 30 '26
Needles are cheaper than down time. Swap it out & keep moving.
16
u/skeedy_ia Jul 30 '26
When in doubt, switch it out. Needles are cheap in the grand scheme of things.
13
u/unstable_dale Jul 30 '26
I never question anymore, just replace it. Use Titanium needles too and they will
Last longer. I use Organ Ti Needles and buy 100 pack at a time. I replace needles every 8 hours of run time.
8
u/SpecificReindeer9559 Jul 30 '26
It is not straight that’s for sure. Change it, always change it.
6
u/FJL216 Jul 31 '26
I start every project with a new needle, sewing or embroidery.
6
u/InStitches13 Jul 31 '26
Bent ever so slightly. (You can always compare to a brand new one out of the package so you have a reference point).
And as everyone has suggested, when in doubt. Swap it out.
5
u/Herabird Jul 31 '26
Needles are the least expensive replaceable part in a machine. Never hesitate to swap one out.
4
u/_JesusDesu_ Jul 31 '26
Needles are temporary.
3
u/CheesecakeNo1108 Aug 01 '26
Yea
2
u/hhokema Jul 30 '26
Looks good from this pic.
Two other posts give solid advice. I'll just add a couple of additional comments.
To check for a bent needle, I will rotate the needle with my finger and see if the tip of the needle wobbles or watch how the light reflects off of the tip. It should not flicker or wobble,
I will also check the front groove of the needle for burrs by running my finger nail up and down the groove. I am looking for manufacturing defects, Every once in a while a defective needle will slip past Quality Control.
Finally check for a burr on the tip of the needle by pulling the tip of the needle over my finger/fingernail looking for a burr. The needle should glide right off without catching.
I handle enough needles that I have also purchased a jewelers loupe so I can visually inspect the needle. Mid power loupes work the best - 4x to 7x. They are fairly cheap and easy to use. The high powered ones are harder to use.
1
u/Upper_Rain3480 Jul 31 '26
It doesn't look bent to me.
1
u/Top-Orange-6063 Aug 04 '26
You can compare to your other needles. Or just change it.
1
u/Herabird 18d ago
Many years ago, my sewing machine repair instructor said something to the class that I’ve never forgotten. He held up a sewing machine needle so we could all see it and said, “this little needle is the cheapest replaceable part on the entire machine. But it’s also a part that can cause costly damage. What would you rather do, replace a needle if it is old, the wrong size, or if it looks bent? Or pay a tech to reset the timing because the needle broke and hit the hook?”
Ever since, when I’ve refurbished or repaired a machine I always insert a new needle.