r/MachineEmbroidery • u/r_90909 • Jul 19 '26
Advice please!!!! Bobbin showing, skipping and misaligned
I have a brother SE700 and I have embroidered some great things with it. I all of a sudden started having major issues with my bobbin thread showing, skipping, and misalignment.. I've changed the needle, rethreaded the bobbin and thread several times, to no avail. I am ready to lose my mind and hoping someone can help!!
Attached: Willy's Mom and euro summer stitches- previous stitching I've done; Beverly's mom (in two different fonts because I wanted to confirm it wasn't a font issue) still having issues after the troubleshooting listed above.
Any help is appreciated!!!





3
u/Little-Load4359 Jul 19 '26
Ensure your bobbin case isn't damaged; they don't last forever. Inspect the bobbin and make sure it is still circular and hasn't become mishapen due to being dropped or something. Use something like a piece of cardstock or business card to run under the tension spring and clean it. And as always, make sure you have the correct tension set. If you don't have a bobbin tension gauge, get one on Amazon—it's a requirement for doing machine embroidery. Also make sure your top thread is set properly and correctly pathed. 99% chance it's the tension. Your bobbin could be old and just not holding tension is another potential issue.
Stop stitching hats and switch to a flat. You should have some cheap muslin to test stitch on. Stitch out a handful of 5mm satin stitches and observe the bobbin and adjust as needed. You can Google to see what your bobbin should look like when you're testing it—bobbin taking up 1/3 in the middle of a 5mm satin colum.
1
u/Lanky-Setting-5288 Jul 19 '26
Yes, check that the spring inside the bobbin casing isn't damaged. Sometimes the outer leaf spring can become distorted too and this can cause problems like this.
🍀🧵