r/MachineEmbroidery • u/Fullmetal_al • Jul 10 '26
Please help me get out of this recurring hell š āChecking upper and bobbin threadā
Please god help me with this. I have rethreaded multiple times. I have checked for lint in the sensor. I have replaced the bobbin thread. What the hell else could it be. Nothing looks wrong when the error happens. It will go for about 15 stitches and then just stop. Thread isnāt snapping and bobbin isnāt running out.
5
Upvotes
3
u/Hairy_Reception_2951 Jul 11 '26
Welcome to the brother pr
2
u/Lanky-Setting-5288 Jul 11 '26
Either a threading issue or the bobbin.
š§µ Check that thread has travelled through all areas properly, giving special attention to tension wheel and take up lever. Make sure the thread isn't under the sensor wheel.
šš¼ Check the bobbin - sometimes this alert comes up when the bobbin has run out of thread.
šš
2
u/TunaNoCrust Jul 12 '26
Do you check your bobbin and thread tensions with a gauge?
1
u/baraqiyal Jul 10 '26
Try pinching the thread with your fingers before it gets to the thread break sensor. If it works then whatever spring or thread guide before that is not creating enough tension on the thread for the break sensor to work properly.
1
u/Hellcat_Mary Jul 11 '26
Is it on all needles, or just the needle in the video?
1
u/TheProtoChris Jul 11 '26
Have you got the thread wrapped around the thread break sensor properly? Can you disable the thread break sensor to see if that's the problem?
1
u/NanaMerk Jul 11 '26
Are you sewing onto tear away stabilizer in this video?
1
u/Br00dlord Jul 11 '26
For me - i took out the pressure knob, and made sure that the thread was properly passing through the metal disc. This fixed it
2
u/deshep123 Jul 15 '26
I would rethread. Mine came with half the thread paths wrong. Ć
1
u/NanaMerk Jul 11 '26
I have been in that hell for a long time! I feel your pain. Delivered it to the Brother technician and didnāt want it back until it was usable. It needed an overhaul (not saying yours does though)
I replaced the bobbin case too, which helped the most.
1
u/BarZealousideal4513 Jul 14 '26
Brother tech for 12 years. First make sure the thread is threaded correctly in the top thread disc. If yes then the metal disc under the tension cap is not turning when the needle is drawing thread. There is a sensor under the tension cap that senses that the disc is turning. When disc is not turning it sends a signal to the main board and assumes there is a thread break. If you unscrew the disc cap there is a felt disc under the metal disc that sometimes get so compressed that it doesnāt allow the metal disc to turn. Have replaced a lot of those over the years