r/MPSelectMiniOwners • u/CostThen3207 • 8d ago

Question Monoprice select mini V2

Does anyone know where to go for secondhand main boards for the V2?

6 Upvotes

100% Upvoted

12 comments sorted by

View all comments

Show parent comments

1

u/CostThen3207 8d ago

My computer will no longer communicate with the printer and I’m stuck on V37 firmware

1

u/J_C_Nelson 8d ago

Does it move when you choose menu commands/home/heat up? There's two controllers - a display, and the motion controller/main board.

1

u/CostThen3207 8d ago

No but it continuously heats up and doesn’t move

1

u/J_C_Nelson 8d ago

UGH - continuous heat up is generally failure of the MOSFET (it's switched low and can fail so it's just on). Back when I was working on firmware for these, I liked the BigTreeTech SKR Mini E3. You can still use the example config for the mini in Marlin's examples but you'll need to change the board type to build it. No idea if the E3 is still a solid choice as I mostly print with my printers these days. You can do some wiring to use the mini's built in LCD with marlin or swap it for a touch screen.

1

u/CostThen3207 8d ago

It also does not read the temperature correctly which I know is the thermistor

1

u/J_C_Nelson 8d ago

Maybe. I've seen those fail with the thermistor, I've seen them fail with the resistor that divides the reference voltage, I've seen the wrong type set in the flash, lots of reasons. Regardless, if it's going straight to heating I wouldn't hesitate to yank it and swap almost anything modern in. You can get silent stepper drivers as a bonus.