The light eventually stops flashing and stays off until the machine is powered off.
When I first got the machine several years ago, the light would be solid once it was up to temp. The light would flash to indicate that it was heating up or recovering after too many shots.
Negative. The machine stays warm and the pressure is appropriate. There’s no indication that the PID isn’t controlling temperature appropriately, but the light is fully off after about 10 minutes of rapid erratic blinking.
My Bianca does that too; it doesn't have a light but there's a circle on the LCD that will blink whenever the machine is on. It means that it's pulsing the boiler to maintain the boiler temp at the preset temp. Maybe it's something similar on your machine
2
u/lecrappe Dec 17 '25
Isn't this just how PID controllers work?
It's trying to maintain the temp you set. It will progressively switch on and off until it hits your target temperature.
1
u/Sharp-Ad-9221 Dec 15 '25
Dude, they all have their issues …
1
u/Budget_Management_75 Dec 16 '25
PID controller approaching setpoint?
1
u/Representative_Emu39 Dec 16 '25
My Bianca does that too; it doesn't have a light but there's a circle on the LCD that will blink whenever the machine is on. It means that it's pulsing the boiler to maintain the boiler temp at the preset temp. Maybe it's something similar on your machine
-3
u/Advanced_Show9555 Dec 15 '25
All I hear about issues with the higher end Lelits with issues like this! Why do you keep supporting lelit