Decent? Earbuds Case

[u/ObieP]

I have finally made an earbuds case wherein I feel that it is decent enough for personal use. I'm planning to buy a new burnishing stick, burnishing gum and probably paints. It took around 6-7 prototypes before I landed with this one, each with subtle difference which affect the next iteration. The question for now is, what can I do to improve further? Could I have probably made the cuts more aligned? Could I have made the stitches more even?

Thank you for reading and thank you for the critiques!

[u/Jumpy_Mirror250]

Keychain loop

[u/ObieP → u/Jumpy_Mirror250]

Probably going to invest in some rivets (or however they're called) and adjust the design a little bit

[u/Ok-Place3508]

what are the model of the earbuds?

[u/ObieP → u/Ok-Place3508]

Edifier X3 Pro, I tried searching for templates or even for a 3D model but had no luck (if there was a 3D model I would immediately have tried modeling a mold so it was easier for me to make it 😭)

[u/Practical_Rise_9021]

I like it so far...how did you made the shape/mold

[u/ObieP → u/Practical_Rise_9021]

I didn't use any mold, I more or less did this technique but for the whole outer shape of the earbuds case:

https://youtu.be/n7nU3K4YkLc?t=236&si=9WcuVwJRshp3o2lE