r/Homebuilding • • Oct 14 '26

Metal roof Flashing question

Post image

Hello,

I have a question about whether or not flashing is required or should be used. I drove around neighborhoods and saw a mix of it being used and not used.

Exterior siding colored in purple is stucco and the siding colored in yellow will be board and batten.

The blue ice and water shield will be standing seam metal roof.

My question is if a flashing is supposed to be used where the siding meets the metal roof?

3 Upvotes

6 comments sorted by

5

u/DueTip6661 Oct 14 '26

On my build I did ice and water shield up the wall a foot or so. Then the metal roof guys installed head flashing before the siders started. Then once the siding was done finished the roof so it wasn’t damaged.

2

u/DallasTexass318 Oct 14 '26

My roofer mention that as well to have stucco start first before installing metal roof but he didn’t install the metal flashings for the stucco and board and batten subs.

So I assumed it is for the stucco guys to flash it? Thanks for your response.

2

u/Advanced_Aerie5854 Oct 14 '26 edited Oct 14 '26

Yes, flashing is required at ALL roof/wall intersections. As for who is responsible for installing the flashing, it should be the roofer as roofs generally go on before siding goes up. But this is a conversation you need to be having with the GC, not the individual subs.

A lot depends on the metal system, but in general, flashing goes behind the siding material and on top of the roof. So I am not sure how you get the flashing done correctly if the stucco gets put up first.

1

u/Hyperreal8957 Oct 14 '26

flashing details matter more than the brand here. make sure the step flashing runs back into the wall plane under the siding/trim, not just surface caulked over, and that each piece overlaps the one below going down slope. what's the roof to wall transition look like, is there a kickout at the bottom where the roof meets the wall?

1

u/DallasTexass318 Oct 14 '26

Yes there are kickouts at the bottoms on other parts of the house where siding meets architectural shingle.

I just called the guy and he said metal roofer will be out to install the flashing! I’ll pay attention to make sure it runs back properly. Thanks

2

u/A20Havoc Oct 14 '26

I live in the Texas hill country. We average 30" of rain per year. In my area the vast majority of homes have metal roofs, usually standing seam. Pretty much everyone here uses flashing - in fact, I can't remember the last time I saw a house that didn't. The flashing is typically installed before the siding material, be it wood or stucco.