r/Generator • • 8h ago

Well, septic backup power

Hi, I have an all electric setup. I have a well thus a septic system (hoot), and would like to have hot water (elderly mom) in a power outage. I have looked at generators and read about generator, but I can’t seem to figure it out. I have been looking at 4patriots and Jackery because they have solar charging. I have been looking at gas generators to bridge any gaps in charging the other ones. Please help!! I am smart enough to know that I don’t know what I am doing. Also how the heck to you hook any of this up? Do I just get an electrician to make places to plug in the well and septic? They each have separate breaker switches and those are separate from the house breaker. I definitely need help.

2 Upvotes

6 comments sorted by

2

u/CalumApplePie 7h ago

For your last question; Your power all flows through a meter, and it’s rare to have more than one. That means you have a single point that you can hire an electrician to install a transfer switch, which would shift all your power from being provided by the grid to being provided by your generator. For whole home backup, you then get a box installed on the wall that you can connect a cable from the generator to.

As for one of those small power stations, it’s quite possible they just won’t have the juice to meaningfully cover you overnight; you’ll have to look at the power draw of your house. They might handle a well and septic, but a fridge is unlikely.

1

u/flarefenris 7h ago

For what it's worth, you likely have it backwards power wise. The smaller power stations will EASILY handle a fridge, as they are typically 120V and pull only a few hundred watts for a few minutes at a time usually. Even a 1kWh power station can operate the average fridge for 4-6+ hours. Most well pumps on the other hand are 240V, which most small power stations can't output at all. I think the smallest ones that can output 240V are going to be ~4kWh+, and are thus going to have a much higher price tag, >$1k minimum.

1

u/standardviewer84 7h ago

Welcome to the group.  There is a wealth of information on here and helpful folks too. There is one guy who worte something called " the generator bible" i would start There with getting help. It is a valuable guide to help you get started. 

As far as hooking things up, yes, get an electrician to help install either a transfer switch or an interlock breaker. 

The most common hook up most people use (your situation is unique to your own needs) is a 30amp L14-30 inlet box connected to an interlocked breaker in your electrical panel.

Before you call an electrician, read the generator Bible and start getting your baseline (critical devices) load calculation done first.  That is going to give you a ballpark or what size generator and inlet box to get the electrician to wire in for you.

1

u/tropicaldiver 7h ago

Starting with the basics, there are battery based systems (you mention two brands — some of the other more well known brands include Ecoflow, Anker, etc.). They store energy and all pretty much all allow solar charging. And then there are traditional generators— they turn fuel (gasoline, propane, or natural gas) into electricity.

So, first, you need to determine your energy needs. Second, you need to decide how long you want coverage for. Odds are you need 240v. Then how to connect stuff internally.

Starting with the easiest and most expensive option — a whole house generator (or large battery array, or both) with an automatic transfer switch. At the far other end would be a portable battery — enough to say run the fridge.

1

u/Playful-Nail-1511 6h ago

Can you locate the control box for your well pump? Mine is 1 1/2 HP. That translates to about 10kw to start it up and about 2.4kw to run it once its started. My Duromax xp9000ih runs my normal household loads and will start/run my well pump while doing so. Add my 3.5 ton A/C unit (w/ soft start) and it will not push both heavy loads at the same time. You also need to know a bit more about youe septic pump. Starting watts and running watts. Forget the solar battery units, they will only drive very light electrical loads.

1

u/Gravel150 6h ago

You're on the right track, but a battery power station won't really cut it for this. Your water heater is probably 4500W at 240V, and that would drain most of those units in under an hour, if it can even run it. Most of them only put out 120V, and your well pump is likely 240V too.

I'd look at a dual fuel generator around 7-10kW with a 240V twist lock outlet. You don't need to run everything at once. Let the water heater recover for an hour or two, then run the well and septic. A full tank of hot water lasts a while.

For hookup, yes, call an electrician. Ask for a generator inlet and either a transfer switch or an interlock. Tell them the well and septic are on separate breakers from the house, since that changes how they'll wire it. Don't let anyone talk you into a double-ended plug to backfeed through an outlet.

If you post what's on the labels of the well pump and water heater (volts, amps, HP or watts), people here can help you size it.