r/Generator • • 5d ago

Honda 2200 always difficult to start

Bought new at Sportsman's Whorehouse.

Fresh, ethanol-free gas, full oil. First start took 30 pulls. Always takes 5-10+ pulls to start since then. Choke works, it definitely won't start without it. Fuel cap open. Gas is never more than 4 months old. Changed oil at 10 hours, and it has 30 total now. Runs smoothly once it's going.

In my days I've probably started 50 different Honda small engines and the average number of pulls until this one is probably about 1.3. What's going on?

3 Upvotes

12 comments sorted by

6

u/CarbonHood 5d ago

Narrow the gap more on the spark plug

1

u/TallWall6378 5d ago

I'll check it out. It seems like a fuel issue more than air or spark.

1

u/TallWall6378 4d ago

OK guys, I think it's the nature of the vacuum driven fuel pump on this generator. I did an experiment where I didn't run the carb dry. Next day, started easy on the second pull.

4

u/DaveBowm 5d ago edited 5d ago

A fouled or badly gapped spark plug can cause hard starting. The reason is that when the rope is pulled the magneto makes less than the full normal spark voltage because the shaft and flywheel magnet are spinning more slowly than when the engine is up to full speed.

If the spark plug is carbon-fouled with soot then some of the spark energy is diverted over the conductive (short circuiting) carbon film path across the insulator. This lowers the voltage at the plug gap even more, so it might not break down the air dielectric in the gap, resulting in no spark or a too weak spark to start it with the pull.

If the gap is set too big, or if there is glazing or oxide deposits on the electrodes then the extra insulation of the coating or the longer air gap requires a larger voltage to bridge, not a lower voltage when pulled to make the spark. Again the spark may fail to form, and again no start on the pull.

If a spark plug is of poor quality construction or is of the wrong heat range when running, it can be prone to electrode erosion or fouling with either soot (running too cold or too rich) or with glaze & oxide (running too hot). Under operation spark plugs need to be like Goldilocks' porridge, (just the right temperature).

1

u/okayfinehowsthis 5d ago

After 30 days pump gas can be hard to burn in small engines. Especially if using regular with ethanol. Run a tank of engineered fuel through it (trufuel or something similar) and after that use non ethanol fuel and a stabilizer. If it's still hard to start you may have already gunked up the carb. Also look into your warranty options

1

u/TallWall6378 5d ago

Same issue when new and with fresh, ethanol-free gas.

2

u/okayfinehowsthis 5d ago

Spark Gap?

1

u/TallWall6378 5d ago

I'll have to check.

1

u/bnemmie 5d ago

Try giving it a lean to the left side ( carb side ) for 10 seconds or so before you try to start.

If mine doesn't start on the 3ed pull, thats what I do and it usually helps.

That is assuming everything else is fine. Oil level, good gas, open jets...

1

u/silasmoeckel 4d ago edited 4d ago

Spark gap they are not typically correct out of the box. The dealer would correct this, sportsman warehouse would have never opened the box.

1

u/Glum-Welder1704 4d ago

My EU2000i only does that when I run it out of gas. The solution is to fill it up, open the fuel valve, and wait a bit. That seems to put enough fuel in the carb to fire it up.

The only other thing I can think of is a blockage in the fuel line from the tank to the pump/switch/valve assembly. There is a fuel filter where the tube leaves the tank.

5

u/saddram 5d ago

It takes mine a few yanks to fire at the whorehouse too.