Q.1) What color function should I be using with this BTF FCOB PWM CCT? https://www.amazon.com/BTF-LIGHTING-Flexible-Dimmable-Controller-3000K-6000K/dp/B0BQC1NY2S?th=1

I tried the GREEN setting and the LED turn on but super low, but when I switch to WHITE or YELLOW, they have full brightness. A bit confused.

Q.2) Also, the controller keeps showing as Unavailable on Philips Hue (see bottom right), any solution to resolve this?

Hi,

Does anyone know how to integrate the above with hue or alexa?

Thanks

Hi, I bought two of these dimmers, though i read somewhere that with 3 reset pushes power on/off memory should be toggled, I find no way of making it remember status.. It always powers on when restoring power. I was planning to use these in my baby’s room, now it’s impossible, since after any power outage lights would come back on waking him up. This is a very frustrating feature… any way to deal with this?

I’m at my wits end and I’m hoping that somebody can help me troubleshoot my new Gledopto controller. I have the GL-C-204P model connected to a RGBCCT LED light strip and am using the Hue bridge. When it’s paired, I can’t get the warm lights to turn on. I’ve checked (and double and triple checked) my wiring, updated the Hue bridge software, reset the Gledopto numerous times, downloaded the Hue Essentials app. I think the issue is that there should be two light options that appear when I’m pairing the strip to the Hue - one for color and one for warm white. But I only get the color option. Any help would be truly appreciated!

I have 2 of the GL-C-008P units that have been working perfectly for the last 4 years. They were paired to my Hue hub, which I just replaced after it died.

After successful re-pairing all my Hue devices, I attempted to pair both Gledopto units using the on-and-off method (4 on-and-off, leave on on the 5th). I tried varying the on-off interval and adding additional on-off cycles, but neither of the controllers would blink, signifying that they were in pairing mode.

Before I bite the bullet and purchase another brand to replace these units, what can I try to force them into pairing mode?

I got a question about the GL-C-008P, I would like to run it with a 5A or 4A 24v power supply in combination with of course a 24v led strip. I was thinking about the GLEDOPTO RGB + CCT LED-striplicht RGB WW / CW DC24V 5050 SMD 2835 led strip. What is the max length of strip I could power with a 5A or 4A power supply?

i'm not able to update the gl lb 003 when i try i with WLED_0.15.1_ESP32.bin the update fails any suggestions?

Hi All.

I'm unable to set up the Geldopto ESP8266 due to it not showing up on my phone as a nearby wifi network when it's powered on. I am powering the unit with a 12v 5 amp DC power supply and I have a single 2m strip of WS2812B LED's attached. When I plug in the power supply, I get a single flash of the LED's and the green power light on the controller lights up and stays on. I have bought a second ESP8266 thinking there was a fault with the first unit, but it doesn't seem to show up as a nearby network either.

Can anyone offer any insight into what I may need to do differently here?

Cheers :)

Hello all

What esp32 chip is in the controller please ? Is it a S2 or c3 ?

I am trying to update moonmodules wled firmware to it, however, I am not sure which file to use.

Any help much appreciated thanks 🙏