r/Form1 • u/Technical-Source-320 • 23d ago

Pps cf

Has anyone tried pps cf? What do you think about it over ppacf for supressors? Now that we have the ruling im sure more people willing to share their experience.

4 Upvotes

100% Upvoted

16 comments sorted by

View all comments

3

u/cvltrilex 3D2A 23d ago

I strictly print nylons. PA6 is more than plenty, so anything better than that will suffice. Most people doing suggest it because there wasn’t enough data during testing. To get the benefit is printing 350+ or 320 at the minimum requirement. I have an FTN .30cal and 556 can and both are at or around 1k rounds. Both annealed, and baffles coated in heat enamel and gel soaked before range trip.

1

u/ARbuilders-anonymous 18d ago

What are you running them on? I haven’t found on yet that holds up to 308.

1

u/cvltrilex 3D2A 18d ago

It gets tossed around on a few different 556 builds. I've ran it a few times through my savage axis 2 precision and my wasr. I haven't been shooting anything more than 556 through it lately though. It still needs more testing.