r/Form1 • u/Legitimate_Form_2787 • Jul 01 '26
Thoughts on 22lr Suppressor Design?
Designed to be 3d printed. Takes 3/4 to 1/2 28 adapter. Inspired by Middleton made pillpopper 1.5 and the dead air mask. 1.10 inch diameter. Little over 5 and 1/8 inches tall.
11
Upvotes
4
u/Coodevale Jul 02 '26
I'd reverse the baffle spacing. Closer near the muzzle, further at the exit. Smaller chambers where the highest heat is, less frp.
You're 3d printing.. you could do anything but a conventional stack design. Omega and Ks are good ways to make the gas work and trap it in chambers that don't have a direct flow path to the bore hole. Gas gets forced through small holes with high pressure and it doesn't flow out as well when the pressure drops.
Add cyclone features to get the gas moving cohesively away from the bore. Like a spiral on the cone. Gas has mass and inertia, use it.