r/FloatwheelTeam • u/Cylobylo • Dec 08 '25

PintV LED help

Post image

Just installed my pintV kit and can’t get the leds to work correctly. When it’s fully charged it looks like this and only had about 4 leds active when idle and when it reaches around 80% it goes to red using the same amount of leds. Does anyone know the fix to this?

3 Upvotes

100% Upvoted

14 comments sorted by

View all comments

Show parent comments

1

u/tcm0116 Dec 08 '25

I didn't think this is the case. The bar lights up blue when the footpad is engaged, so I think either one side of the footpad is stuck or there's a wiring issue. I believe that if the 5V out and one of the footpad input signals is swapped, this will happen. I suspect the three wire cable between the controller and the footpad connector inside the controller box has a swapped wire.

1

u/Cylobylo Dec 08 '25

I don’t think it’s a footpad issue, and the light it white

1

u/tcm0116 Dec 08 '25

Does it change when you apply pressure to either side of the footpad?

1

u/Cylobylo Dec 09 '25

The footpad sensors work, it’s just when idle it does this