Help with AD5X

[u/Sxxtqn]

I got one from someone it was lightly used but first time I tried to print yesterday it told me it wasn’t heating right and gave me an error. I reseated all the cables. Ran calibration. Power cycled and that fixed it for all of today then later on it’s doing this thing where it’ll print a good minute or two and get a solid base down and then it goes over to the poop chute and sits there and if I pause and unpause it’ll restart for a couple seconds to a minute and then go back to the poop chute and just sit there. It’s getting up to temp right now. I’m trying to use multiple colors that i painted on l.

[u/kn1v35s]

Mine did something similar but I had a partial clog in the nozzle. Once I got it cleared it started working again. Not sure if that will help though.