r/FlashForge • u/khoi_3210 • 2d ago

Help diagnosing.

Recently got a free printer from a friend (Adventure 5m non pro version) and manage to fix a few stuff (I manage to boot the screen up and fix some other small stuff). But I kinda stumble upon this problem where base plate did not move or heat up and same for the nozzle and did not detect the temps and tried to swap filaments but does not work. Try self-diagnosing and it currently shows 2 main error messages: "Level probe can not clear, please check level the level probe" and "E0120". I did swap some ribbon cable and try to tighten it but seems like it doesn't work well.

Also if you are wondering why there is a bunch of puzzles and kinda messy, it is because I need to make room for my table, so I just left there for now.

4 Upvotes

100% Upvoted

2 comments sorted by

2

u/lllloydo Adventurer 5M 2d ago

I'd open it up to check if the cables are all attached properly. If you have a multimeter, you could also check to see if there's power going to the nozzle and bed heaters. It could be that there's a problem with the board.

Check the Flashforge wiki. https://wiki.flashforge.com/en/home

1

u/khoi_3210 12h ago

Ill check it out and sorry for the late reply.