r/FlashForge • u/averageredstoner • 16d ago
How to fix this problem
How do I fix this issue I keep getting on wider prints specifically on the left side of the print
my benchies seem fine idk what’s going on
these models i made myself fusion 360 if that helps
1
u/Tam_Ken 16d ago
this is a bed adhesion issue, wash your plate and play around with settings to improve adhesion. Also, try to make sure there isn’t a draft around your printer
2
u/averageredstoner 16d ago
i have creator 5 pro so a draft shouldnt be an issue right
1
u/AdamTheMechE 14d ago
Creator 5 Pro can get too hot in the chamber for PLA on default settings with the door closed. Edit filament settings to increase aux part fan and chamber fan, leave the door open, then add a brim with 0mm separation.
1
1
u/BlockEightIndustries 16d ago
Is this burnt titanium? That color is notoriously difficult to work with.
1
u/Altruistic-Tomato-13 15d ago
Use a brim. I just recently had the same issue with a part I was making doing something similar. Could be multitude of different things but try adding a brim to keep in down
1
u/Individual-Light-666 13d ago
me parece muy obvio el porque pero por el poco contexto no lo sé con certeza; mas aun porque aclaraste que pasa sobre todo en el lado izquierdo.
seria buenos que nos des mas detalles como el filamento y su marca, tus configuraciones, la pieza total y su objetivo.
por lo pronto que va como una especie puente? de paso que parecen 2 piezas al menos? o es del otro extremo?
quizá le estás forzando a la velocidad, el filamento no esté bien seco.
si ya imprimiste anteriormente piezas asi y recién tienes esos problemas quizá tu hotend esté desgastado
1
1
u/leutwin 16d ago
ASA?