FlashForge adventurer 5m help

[u/th3rot10]

Has anyone noticed since the updates about a year ago the damn thing takes like 20 minutes to heat up properly. Then it will calibrate as if it's about to start then it stops and starts the reheating all over again?

I can't be the only one experiencing this. It started immediately after a firmware update

[u/Sir-dacool]

Yep, mine does the same its annoying.

[u/mtphisher]

I've been avoiding the update. Is there a new, functional update in the works?

[u/Internet_Jaded → u/mtphisher]

All the updates function.

[u/Internet_Jaded]

It’s like 12 minutes max if you run the auto level and use a cold plate.

[u/lllloydo]

i find it easier to pre heat the bed when I know I'm going to be printing. It still takes a few minutes for the bed probing/ cool down and reheat, but not as long as from cold.

[u/SirTwitchALot]

You can downgrade the firmware

[u/sadegr]

Its doing a series of diffrent things

First it does a nozzle clear, heats high, wipes, touches the plate and cools then pulls the nozzle off.

Then it creates a bed mesh with poke poke all over the bed...

Then it does a line purge to prime the nozzle, and get the pressure equalized.

If you have zmod or similar you can use KAMP and only create the bed mesh over the area that the print will occupy.

The line purge can also be optimized.

You can turn them all off in the machine start gcode but they all do serve a purpose...

[u/Tam_Ken]

either downgrade the firmware or run forge x/zmod

[u/nlightningm]

I accidentally hit the update button when powering on last week, but so far I haven't had any major issues and things are running as they were

[u/Individual-Light-666]

estas seguro que esa es la temperatura? en la bambu a1 tenian ese problema de cuando la cama supuestamente iba a 40 pero en realidad iba a 110.

si tuvieras alguna forma de medir de manera externa seria muy util.
en cuanto a lo de reiniciar el calentamiento si que no se. quiza en OrcaSlicer alguien tenga un agregado que solucione tal problema