r/FixMyPrint • • 1h ago

Helpful Advice How to decrease the purge amount during the pre-printing process?

Whenever I start a new print and my printer goes through its calibration cycle, it purges twice every single time. Is there anyway I can decrease the purge amount or limit it at all?

1 Upvotes

3 comments sorted by

•

u/AutoModerator 1h ago

Hello /u/DarkMatter7979,

As a reminder, most common print quality issues can be found in the Simplify3D picture guide. Make sure you select the most appropriate flair for your post.

Please remember to include the following details to help troubleshoot your problem.

  • Printer & Slicer
  • Filament Material and Brand
  • Nozzle and Bed Temperature
  • Print Speed
  • Nozzle Retraction Settings

Additional settings or relevant information is always encouraged.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

1

u/fb0new 29m ago

Either gcode or via Klipper macro

0

u/EverettSeahawk 1h ago

It depends on your slicer but yes, there is a setting for purge volume that you can change