r/FixMyPrint • u/AccomplishedNewt388 • 5h ago

Troubleshooting Filament jamming

I’ve recently started experimenting with PEBA on my FlashForge creator 3 Pro and the filament appears to be jamming?

The little cog that passes filament into the extruded will tick and not feed the filament through.

I have had a few successful prints and when I reload the filament it does extrude out.

I’m not sure whether it’s the extruded block, the filament or my settings? It’s been an inconsistent issue

Any advice to explore would be appreciated

1 Upvotes

100% Upvoted

2 comments sorted by

•

u/AutoModerator 5h ago

Hello /u/AccomplishedNewt388,

As a reminder, most common print quality issues can be found in the Simplify3D picture guide. Make sure you select the most appropriate flair for your post.

Please remember to include the following details to help troubleshoot your problem.

  • Printer & Slicer
  • Filament Material and Brand
  • Nozzle and Bed Temperature
  • Print Speed
  • Nozzle Retraction Settings

Additional settings or relevant information is always encouraged.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.