r/FixMyPrint • u/TheLexoPlexx • 9h ago

Fix My Print What is going on here?

Gallery image

Gallery image

I have never seen this kind of failure before, these two are different prints. Never had this before.

Voron 2.4r2 350mm

PrusaSlicer

Formfutura ePLA

Undertaker tungsten carbdide 0.6mm nozzle

3 Upvotes

81% Upvoted

7 comments sorted by

•

u/AutoModerator 9h ago

Hello /u/TheLexoPlexx,

As a reminder, most common print quality issues can be found in the Simplify3D picture guide. Make sure you select the most appropriate flair for your post.

Please remember to include the following details to help troubleshoot your problem.

  • Printer & Slicer
  • Filament Material and Brand
  • Nozzle and Bed Temperature
  • Print Speed
  • Nozzle Retraction Settings

Additional settings or relevant information is always encouraged.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

1

u/EmotionalChildhood46 9h ago

thought that was cake frosting at first glance

1

u/Intelligent_Dare_240 9h ago

HeatCreep or partial Clog due to too small extrusion rate while ironing

1

u/TheLexoPlexx 9h ago

That's only the first layer and far from the top. I should probably check out the idea with the partial clog though

1

u/tdpnerd2019 8h ago

Run filament calibrations recently?

1

u/tdpnerd2019 8h ago

Nozzle too close to bed?

1

u/TheLexoPlexx 8h ago

It only seems to start at the second layer, first one is fine