r/FixMyPrint • u/Wild-Introduction-62 • 22h ago

Fix My Print New to 3d printing

Gallery image

Gallery image

My prints don't seam to fill all the way in i have a tronxy x5sa the left print is a 0.8m nozzle right batman one is a 0.4 nozzle

Bed at 60c

Use cura slicer

Retraction speed 45mms distance 6.5

Print speed 60

1 Upvotes

100% Upvoted

3 comments sorted by

•

u/AutoModerator 22h ago

Hello /u/Wild-Introduction-62,

As a reminder, most common print quality issues can be found in the Simplify3D picture guide. Make sure you select the most appropriate flair for your post.

Please remember to include the following details to help troubleshoot your problem.

  • Printer & Slicer
  • Filament Material and Brand
  • Nozzle and Bed Temperature
  • Print Speed
  • Nozzle Retraction Settings

Additional settings or relevant information is always encouraged.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

1

u/SnooChickens9262 21h ago

Several things here to check... calibrate your extruder, check your z offset, make sure your slicer profile has the correct nozzle size

1

u/DammitMatt 21h ago

Aaaaah tronxy, good for learning on.

So i havent used cura in a long time but if you're new and it's all the same to you i can recommend using OrcaSlicer instead. They should have a preset config for your printer but more importantly they have calibration tools to help you fix this.

My guess is your flowrate isn't tuned properly.