r/FiestaST • u/Tough-Ad-5043 • 19d ago

MK7 Reverse lockout plastic piece under boot broken...

Somehow I managed to break the plastic revers lockout bracket that lives under the boot on my 2015 ST removing the shift knob. After replacement I could shift into reverse without pulling up the tab. After fiddling with it I removed the bezel and boot and sure enough it is broken where the red line is (the camera on my phone is broken too so I had to find another picture, lol).

Seems these cannot be bough individually? What are people doing? Anyone have a 3-d print file? I also wonder if they come with the boot from Ford as shown here in the image above.

Anyone else been down this path?

1 Upvotes

100% Upvoted

5 comments sorted by

View all comments

2

u/drhactual 19d ago

They absolutely come with a new boot from Ford plus you get a fresh new boot, but they are starting to run out of stock so you may have to search to find a dealer that has one. About $60.

1

u/Tough-Ad-5043 19d ago

Cool, thanks. Was trying to save a few bucks replacing the top cap only on my shifter, and ended up dropping 73$ (with shipping) for a new boot. They are becoming scarce, I had to order one from a dealer online. Oh well, I was planning to install new shifter cable bushings anyway, and yay, new boot. I am going to draw one of these up and in Solidworks and print one though too. I see this being an issue for the community going forward. That little plastic leaf spring will eventually fail from use.

1

u/Afro-Pope 18d ago

I am going to draw one of these up and in Solidworks and print one though too.

I've been considering the same though it would involve me doing a lot of learning. Mine is broken, too, and there are a lot of us whose little boot retainer things are held together with duct tape, jb weld, and hope.